Making the Cut: Benchwork and Lumber

Needless to say, this Toyota Carolla was not designed for hauling 8-foot sections of lumber.

Needless to say, this Toyota Carolla was not designed for hauling 8-foot sections of lumber.

Benchwork isn’t fun, but it’s necessary.  If I could just skip to building scenery I would, but I realize that understanding it is important to make sure the layout is stable.

Because I live in an apartment, I need my benchwork to fit the following requirements:

  1. It cannot attach to any of the walls.
  2. If I don’t want to build new benchwork when I move, it must be semi-portable.  Thus…
  3. It must fit through the door.

Through research, I came across the “domino” concept: building the layout as separate tables which can be disconnected from one another.  Each table is relatively light and can stand on its own (which is slightly ironic since it is called a “domino”).  The layout will be supported by four tables: one under the Knitting Mill, one from the left side of the room to between the end of the river and the turntable (4.6 ft), one from there to the switch leading to Mohawk Asbestos & Insulation Co (3.6 ft), and one from there to the right side of the room (4.8 ft).  The layout is 2 feet wide, making the entire surface area 32 square feet.  These tables will be bolted together using carriage bolts to make assembly and dis-assembly easier as well as ensure the tables hold together.

The legs will be 2×4 lumber, the top will be extruded foam, and everything else will be 1×4 lumber.  Initially I planned to use a combination of plywood and extruded foam for the top, but using just 1 1/2 inch foam is lighter and saves money since the tables do not need to support a lot of weight.

I made my calculations and checked them twice before heading to my local Home Depot.  I purchased 13 8-foot sections of 1×4, 8 8-foot sections of 2×4, and one 4×8 sheet of extruded foam.  The employees there cut the extruded foam to the measurements I needed, which was very helpful.

I drove this lumber to a college professor who was willing to help me cut the lumber to the dimensions I needed.  Top Tip:  If you’re new to layout construction, it’s great to seek the help of a professor who is very familiar with math (Professor of Statistics).  He pointed out that while I did have enough lumber for my design (barely, I cut it close), I didn’t have anything extra in case any of the cuts should go badly.  Together, we worked out the math to ensure all of the necessary cuts could be made.  All of his cuts were successful, and I gave him an invitation to operate a train once complete.

Being without power tools is difficult for layout construction, but I can’t justify buying them at this stage since I do not need them for anything else.  I have transported the freshly cut lumber to the apartment, and when I can borrow someone’s tools (and their expertise, as that is always helpful), then I can take the next step and build the benchwork.



Leave a Reply

Fill in your details below or click an icon to log in: Logo

You are commenting using your account. Log Out /  Change )

Google+ photo

You are commenting using your Google+ account. Log Out /  Change )

Twitter picture

You are commenting using your Twitter account. Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. Log Out /  Change )


Connecting to %s